Parallax 28108 QTI Line Follower AppKit for the Boe-Bot
SKU: PLX-28108
Overview
QTI Line Follower AppKit for the Boe-Bot
OVERVIEW
This kit uses QTI infrared emitter/receiver modules to easily enhance the line-following capability of "your Boe-Bot Robot" Mount three or four sensors underneath the Boe-Bot chasis, and adjust the position to detect lines of different widths. Learning to use the QTI is easy with the illustrated instructions and example BASIC Stamp code provided. This kit includes all the circuit and sensor hardware you need to add QTIs to your Boe-Bot
Key Features:
- Designed for close proximity infrared detection
- Use as a digital sensor array to detect black lines in order to follow electrical tape courses or navigate mazes
- Use as an analog sensor to detect shades of gray
- Challenge your friends by setting up Boe-Bot line following competitions!
Note: You will need to supply your own Boe-Bot white poster board, and black electrical tape.
Use as a digital sensor array to detect black lines in order to follow electrical tape courses or navigate mazes
Use as an analog sensor to detect shades of gray
Challenge your friends by setting up Boe-Bot line following competitions!
Kit Contents:
This kit includes all the circuit and sensor hardware you need to add QTIs to your Boe-Bot:
(4) 10 k 1/4 watt resistors
(4) 3-pin male-male headers
(4) QTI sensor modules
(4) 3/8" 4-40 pan-head screws
(4) nylon washers
(4) 1" round standoffs
(4) 7/8 inch 4-40 pan-head screws
(4) ½inch round spacers
(2) bags of 10 3" jumper wires
(4) 10 inch servo cable extenders