Product Description

Troubleshooting Relay Systems:

Understanding and Troubleshooting Relay Ladder Circuits has never been easier 

      This is a powerful 5-part training course in troubleshooting Relay Control systems. As with all UCANDO training products, the information contained in the relay training program is very practical and can be used on a daily basis. RC-5 contains all materials necessary to train 5 people. RC-10 contains sufficient material for 10 people. Both training programs contain complete DVD lessons, workbooks, pretests, final exams and a leader guide. Suggested training time with final exam is 20 hours. 

Relay Training Part 1:

      Day 1 begins with a pretest. After the pretest, the students examine basic electrical components like the 3-phase disconnect and circuit breaker. They will also examine fuse classifications, overload heaters, control transformers, push button switches, relays and motors. In the first day they will also learn about single phasing and reversing 3-phase motor rotation. 

Relay Training Part 2:

      Training session 2 continues with electrical component operation. In part 2 they will learn about latch relays, lamps, limit, pressure, flow, thermal, foot, proximity, float, key, rotary, multi-stage, push-to-test and maintained push button switches. Also covered in part 2 are timers, timer contacts, solenoids, potentiometers, diodes, rectifier operation, SCR's, triacs and more. 

Relay Training Part 3:

      During the third training session your students will examine cable connectors and terminal strips. After completing basic component operation, the program provides an introduction to relay circuit operation. Part 3 concludes with common Safety procedures which should be followed by all employees or students when working on any electrical system. 

Relay Training Part 4:

      The fourth session provides an in depth understanding of relay circuit operation. They will learn control fundamentals. The students will learn the difference between control devices and output devices. They will learn about relay ladder sequencing and how to wire control transformers for both high and low 3-phase voltage potentials. At the end of their fourth training session, your students will be able to read and understand relay ladder diagrams. 

Relay Training Part 5:

      The final training session contains useful troubleshooting tips and techniques. Problems such as locating broken wires, locating shorted components, how to find the cause of intermittent failures and how to locate the cause of a blown fuse and many other common electrical problems are all covered in part 5. The final exam is also administered in this training session. 

      UCANDO training programs are complete. These programs include pretests, final exams, workbooks, DVD training sessions and a leader guide. Simply follow the steps outlined in the leader guide to provide high quality training at a fraction of the cost of many other training products. You will be amazed at the ease with which the relay training program can be presented by your own trainer.