• 0.001 inH2O resolution at less than 40 inH2O; 0.01 inH2O resolution over 40 inH2O
• Enough range and resolution to perform low pressure and draft measurements on high efficiency gas and oil fired equipment.
• +/- 120 inH2O range, over-pressure protected to 200 inH2O
• Enough range for low side regulator adjustments and protection against pressure spikes
• Temperature compensated to ensure repeatable measurements
• Pressure measurement is not affected by ambient temperature
• Dual input differential
• Troubleshoot and setup two stage pressure switches
• Seven units of pressure: inH2O, mbar, KPa, PSI, mmH2O, mmHg, inHg
• Enables equipment adjustments to be made easily
• Trim mode to stabilize readings

Applications:

• Adjust appliance regulators
• Setting delivery pressures
• Leakage “shut-in” tests
• Replace messy U-tube manometers
• Test low pressure gas systems for leaks
• Regulator adjustments for pressure and lock-up tests
• Test pressure switch operation on a 2-stage gas furnace in both positive and negative pressures
• Measure furnace and boiler draft

Specifications:

• inH20 ±120
• mbar ±300
• kPa ±30
• psi ±5
• mmH20 ±3,000
• mmHg ±220
• inHg ±9
• Resolution (max) 0.001 inH2O
• Accuracy +/-(0.2% of full scale)
• Over Pressure 200 inH2O
• Power Supply 9V battery
• Operating Temp. 32°F to 104°F (0°C to 40°C)
• Operating Hum. 0% to 80%
• Storage Temp. 14° F to 122° F (-10°C to 50°C)
• Auto Off 20 minutes
• Input Type Dual / Differential
• Trim Mode Yes
• Auto Zero Button Yes
• Min/Max Record Yes
• Units of Measure 7 (See range above)
• Data Hold Yes
• Backlight Display Yes