Parallax 32111 Propeller Professional Development Board

The Propeller Professional Development Board is a high-quality, fully-integrated development platform for the Propeller P8X32A multicore microcontroller.  A wide variety of peripheral connectors and typical I/O devices such as LEDs and buttons are built into the board, providing the developer with an ideal platform for rapid Propeller project development.

Key Features:

• On-board voltage regulators provide 5 V and 3.3 V supplies for your application circuits  
• Contains the most common I/O interfaces for the Propeller chip on one board 
• Large breadboard area gives plenty of room for additional components and devices 

Key Specifications:

• 40-pin DIP socket for P8X32A-D40 Propeller microcontroller
• P8X32A-D40 microcontroller included
• 24LC256 32 KB EEPROM included
• 5 MHz crystal included
• 5V and 3.3V regulators on board
• Built-in USB programming/communication interface
• Six blue 16-segment LED displays
• Sixteen blue discrete LEDs
• L293D high-current driver for motors, solenoids, etc.
• Eight active-low pushbuttons with 3.3V pull-ups
• Eight active-low DIP switches with 3.3V pull-ups
• Two 10 k-ohm potentiometers
• Eight servo headers with selectable on-board/external power source
• DS1302 real-time clock with battery backup/charging capability
• MAX4411 headphone amplifier with 1/8" stereo audio jack
• MAX3232E RS-232 DCE interface
• RCA jack for broadcast TV or composite video
• Two PS/2 ports with 5V power and 3.3V pull-up resistors on clock/data lines
• 15-pin HD D-sub connector for VGA monitor
• Two ground terminals for logic analyzer/oscilloscope probe ground clips
• Voltage requirements: 7–12 VDC
• Current requirements: 59 mA quiescent current (@ 12 V)
• Communication: USB serial programming interface (FT232R)
• Dimensions: 9 x 5.25  x 0.75 in (23 x 13.5 x 2 cm)
• Operating temp range: 32 to 158°F (0 to 70°C)

Note:  Requires a power supply and a USB A to Mini-B cable for programming. Recommended power supplies are #750-00007 (12V) or #750-00009 (7.5V). Recommended USB cable #805-00006.

Downloads & Resources:
Propeller Professional Development Board Product Guide (.pdf)
Propeller Professional Development Board  Rev A Schematic (.pdf)